3 Replies Latest reply on Oct 5, 2016 6:26 PM by yutaka.suwa

    Adaptivity Threshold

    yutaka.suwa

      In bcm43455 FW, I would like to adjust threshold of Adaptivity active, transmission stop by this level.

       

      Current parameter is below

      eu_edthresh2g=-65

      eu_edthresh5g=-65

      This information is descrived in nvram_ap6255.txt, at /mnt/mtd.

       

      These value are only avalilable -75 to lower, -75dBm MAX.

      If I set threshold value is -65dBm by "eu_edthresh2g=-65", adaptivity active level is still -75dBm.

       

      Could somene instruct how to adjust threshold AND are there any other parameter to enable threshold?

       

      Thank you