- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
We are starting Mass production with cy8c4128lqi-bl553 and cy8c4128lqi-bl543 uP.
We purchased the Miniprog3 programmer. Is this programmer good to program 100K and more uP?
Which SW do you recommend for this ? Cypress Programmer ?
Thanks
Solved! Go to Solution.
- Labels:
-
BLE
- Tags:
- cy8c4128lqi-bl543
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, the miniprog3 is a program debug kit and can be used for the mass production of PSoC devices. You can use the PSoC Programmer 3.22.2 or later version to program the devices with Miniprog3. You can refer to the below link for more information on programming any Cypress Device.
https://www.cypress.com/products/psoc-programming-solutions#tabs-0-bottom_side-6
Thanks,
Pradipta.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello. Past calendar year I successfully defended my coursework, and eventually moved on into the very last stage of my scientific tests at the college. I owe lots to these men, only they could compose the paper so competently and gracefully. I will request assistance once more and again https://www.rephraser.net/
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, the miniprog3 is a program debug kit and can be used for the mass production of PSoC devices. You can use the PSoC Programmer 3.22.2 or later version to program the devices with Miniprog3. You can refer to the below link for more information on programming any Cypress Device.
https://www.cypress.com/products/psoc-programming-solutions#tabs-0-bottom_side-6
Thanks,
Pradipta.