Nov 19, 2020
02:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 19, 2020
02:48 PM
We are starting a project using the sparkfun sound detector. The detector has three pins, envelope, gate, and audio. Each outputs a voltage in regards to the volume of the sound detected. I was wondering which pins on the psoc 4 would be best to use to read these voltages.
1 Reply
Nov 19, 2020
08:48 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 19, 2020
08:48 PM
Hi,
If the ADC is to be used measure the analog input, port 2 is recommended as it uses minimal routing resources. Most of the pins have analog peripheral connectivity through the AMuxBus, then again additional routing overhead and routing resource usage can be avoided if Port2 pins are used for analog input.
Best Regards,
Vasanth