0 Replies Latest reply on Nov 9, 2020 7:42 PM by YoIs_1298666

    About UART RX and TX polarity inversion and Wake up from Deep Sleep mode for PSoC4000S

    YoIs_1298666

      Hello,

       

      Please tell me how to enable both RX and TX polarity inversion and Wake up from Deep Sleep mode from UART.

      If I set it as shown below, a warning will occur.

       

       

      Is it needed if I output TX and RX from the terminal once, return it to SmartIO, invert it, and output it again?

      Best regards,

      Yocchi