- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have developed the USB HID keyboard application.. But unable to receive the data send from computer to keyboard... i.e to turn on/off command for CAPSLOCK/NUMLOCK/SCROLLLOCK led...
Can i get any reference or specific file or routine where i can receive that data & turn on or off leds accordingly......
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BhSa_4078721,
Can you please let us know which device and IDE are you using?
Also, we have HID code examples, which you can refer to get a more clear understanding. You can refer this 3-button HID mouse code example here : https://www.cypress.com/documentation/code-examples/ce226423-psoc-6-mcu-usb-hid-mouse-application. This code example demonstrates how to setup a USB HID descriptor to implement a 3-button mouse.
Also, you can refer this application note : https://www.cypress.com/documentation/application-notes/an57473-usb-hid-basics-psoc-3-and-psoc-5lp. There is a code example which demonstrated USB HID mouse implementation : https://www.cypress.com/documentation/code-examples/ce95394-usb-hid-mouse-psoc-35lp .
Please let us know in case of further queries.
Best Regards,
Aashita
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using CY8C4246AZI-L445....IDE Psoc4....
The mentioned link is for mouse...i want to create for keyboard.
I have already developed the usb keyboard code....its working fine.....
i want to control the capslock/numlock/scrolllock leds....
I have also added the OUT endpoint in sch component and written the below code to turn on leds
/* Check to see if the OUT Endpoint is full from a recieved transaction. */
if(USBFS_1_GetEPState(OUT_ENDPOINT) == USBFS_1_OUT_BUFFER_FULL)
{
CAP_Write(1); // capslock led...written only for testing purpose
/* Get the number of bytes recieved */
OUT_COUNT = USBFS_1_GetEPCount(OUT_ENDPOINT);
/* Read the OUT endpoint and store data in OUT_Data_Buffer */
USBFS_1_ReadOutEP(OUT_ENDPOINT, USB_Out_Keyboard_Data, OUT_COUNT);
/* Re-enable OUT endpoint */
USBFS_1_EnableOutEP(OUT_ENDPOINT);
}
but still i didnt get positive result..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi BhSa_4078721,
Can you please check the section "APPENDIX C: USB KEYBOARD IMPLEMENTATION" in the USB HID spec provided on the USB-IF here : Device Class Definition for HID 1.11 | USB-IF ?
After going through the code mentioned by you, the flow of the firmware seems to be correct. Can you please check the REPORT_DESCRIPTOR as provided in the USB-HID spec?
Best Regards,
Aashita
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have checked the APPENDIX C and also REPORT Descriptor for keyboard...I have compare it with my report descriptor...there are minor difference in input & output field...but how to edit that?
I have attached my report descriptor.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content