Nov 01, 2020
04:49 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 01, 2020
04:49 PM
Hi,
I have solved this problem by referring to USBFS: Use of APIs in DMA Auto Mode Memory Management
and as such have edited this question. Thank you.
Labels
- Labels:
-
PSoC 4 Architecture
2 Replies
Nov 01, 2020
10:52 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 01, 2020
10:52 PM
Hi,
I tried opening your project but I am getting the following message:
In PSoC Creator you could can right click on the project in the workspace and select Archive Project/Workspace and then reattach the project in this thread.
Also note that when in debug mode the firmware should run freely until the USB is recognized by the HOST.
You can refer to the KBA article: Issue while Debugging a PSoC® 3/5 USB Firmware – KBA89230
Best Regards
Ekta
Nov 02, 2020
08:35 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 02, 2020
08:35 AM
Hi,
I have tried reattaching the project, hopefully it doesn't give you an error?