- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
I am completing my project. I have a plan to make a prototype board. The program is tested on development board CY8CKIT-030. the PSoC part number is CY8C3866AXI0-040 on the board. What is the minimum circuit requirement to make a prototype board and program the prototype board using Miniprog-3. Can someone share the schematic.
Thank you
AK Singh
Solved! Go to Solution.
- Labels:
-
PSoC 3
- Tags:
- psoc3
- psoc3 miniprog
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AK Singh,
PSoC 3 and PSoC 5LP device family has almost same Hardware design considerations. Please go through the following application note:
You can also see that CY8CKIT-050 (PSoC 5LP kit) and CY8CKIT-030 (PSoC 3 kit) are almost same.
For PSoC 5LP device we have a very simple kit named CY8CKIT-059 with minimum circuiry. Link given below. You can refer it and follow the same for creating a PSoC 3 board. You can get the schematic of this kit from the same page.
Hope this helps!
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi AK Singh,
PSoC 3 and PSoC 5LP device family has almost same Hardware design considerations. Please go through the following application note:
You can also see that CY8CKIT-050 (PSoC 5LP kit) and CY8CKIT-030 (PSoC 3 kit) are almost same.
For PSoC 5LP device we have a very simple kit named CY8CKIT-059 with minimum circuiry. Link given below. You can refer it and follow the same for creating a PSoC 3 board. You can get the schematic of this kit from the same page.
Hope this helps!
Thanks
Ganesh