2 of 2 people found this helpful
Please let me confirm if you call the function Opamp_0_Start() in your initialization code.
The Opamp will work only after an initialization code is invoked.
1 of 1 people found this helpful
I think that Noriaki-san's suggestion is correct.
But one more thing we can make a mistake here is the configuration of Opamp
Mode: Follower (You've done this)
Output: Output to pin
Compensation Capacitance: High (I think this was default)
So I tested this with my CY8CKIT-042
CyGlobalIntEnable; /* Enable global interrupts. */
/* Place your application code here. */
I used my trusted FRDM-KL25Z's funcgen for the input source.
Oscilloscope wave form
Red: input signal
Yellow: output signal
Thanks! It did the trick!
Very helpful! I searched it for days and then finally decided to post here.Worth the effort!