FCC regulatory testing for CY8C4248L MCU

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
Dmgo_4352736
Level 1
Level 1

Hello Forum!

Our project uses CY8C4248L mcu and we are about to start FCC intentional radiator testing. The Lab we are using is asking for a tool so it will be possible to control channels, power, modes, etc. during the test. What kind of Cypress development sw / tool can we use for that? Third-party dev. tools?

Any advice/link will be greatly appreciated!

0 Likes
1 Solution

Hi Dmitry,

I got it. I was confused after seeing the part number as CY8C4248L and thought it is a non BLE device.

Please go though the KBA from the link below. Using this information, you can set the different power levels, different carrier frequencies to the device.

Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073

Please go through it and kindly update if you need more information.

Thanks

Ganesh

View solution in original post

0 Likes
4 Replies
VenkataD_41
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hi,

You can use PSoC Creator software and Kitprog/Miniprog programmer and write the firmware accordingly to control the internals of PSoC.

What is the software that you are using for your application development?

Thanks

Ganesh

0 Likes

Hi Ganesh,

Yes, we have used PSoC Creator software and Pioneer dev kit for the

development of our project. Now, our compliance lab is asking us to provide

a way for them to control radio on the chip: i.e. set the transmitter

channel(s) and power to test our product's compliance with FCC intentional

radiator requirements. Do you know if Cypress provides any special tool for

that (like Renesas BTTS.exe for example)?

Thank you,

- Dmitry

On Sun, Sep 27, 2020 at 9:46 PM GaneshD_41 <community-manager@cypress.com>

0 Likes

Hi Dmitry,

I got it. I was confused after seeing the part number as CY8C4248L and thought it is a non BLE device.

Please go though the KBA from the link below. Using this information, you can set the different power levels, different carrier frequencies to the device.

Test Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073

Please go through it and kindly update if you need more information.

Thanks

Ganesh

0 Likes

Thank you, Ganesh!

This is exactly what we need.

Best regards,

- Dmitry

On Mon, Sep 28, 2020 at 12:03 AM GaneshD_41 <community-manager@cypress.com>

0 Likes