Sep 10, 2020
07:59 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 10, 2020
07:59 AM
Hi,
Trying to find this info in the datasheet(s), but can't really say for sure.
- On the CY8C4248BZI-L489, are there ANY pins that is not Hi-Z in xres vs early-boot?
I think I know the answer but need to be sure that there aren't any hard scb peripheral blocks that happen to be active low or high during boot.
Thanks David
Solved! Go to Solution.
1 Solution
Sep 13, 2020
10:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 13, 2020
10:08 PM
Hi David,
All the pins are in HiZ mode in during start-up. Kindly check the following KBA.
GPIO State during Startup in PSoC 4 - KBA227963
Best Regards,
Vasanth
2 Replies
Sep 13, 2020
10:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 13, 2020
10:08 PM
Hi David,
All the pins are in HiZ mode in during start-up. Kindly check the following KBA.
GPIO State during Startup in PSoC 4 - KBA227963
Best Regards,
Vasanth
Sep 15, 2020
09:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 15, 2020
09:57 PM
thx!