I tested with My CY8CKIT-062-WiFi-BT,
but naturally I could not reproduce the problem.
But I could think of a couple of possible reasons (there could be many more though)
(1) The Device Data is not installed
(2) The project's target is a different device
For (1), we could download and install PSoC Programmer from the URL below.
Please select the newest one, as of today it is PSoC Programmer 3.28.7.exe
For (2) in my PSoC Creator the device was CY8C6247BZI-D54
I just created a simple Green LED blinker project and attached.
FYI, I'm using PSoC Creator version 4.3
Design01.cyprj.Archive01.zip 1.3 MB
It looks from your Select Debug Target window that it could not find the Device listed in the the project.
There are generally two reasons for that.
- PSoC Creator doesn't have a configuration for that device. If so, make sure you are using PsoC Creator 4.2 or later. This device was available only on later Creator releases.
- The project target device does not match that of the Kit you've plugged in to your PC.
When you use an example project, the project may have been originally targeted for a different device.
The one used in the CYC8KIT-062-WiFi-BT is CY8C6247BZI-D54. If the device doesn't match, select the "Device Selector..." menu item and chose CY8C6247BZI-D54.
From the screenshot, I see that the voltage detected is 1.1V which is strange because I would expect it to be nearly 1.8V when VDD is set to 1.8-3.3V variable position. Can you please set VDD to 3.3V position (SW5) and see if it works?