- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the maximum throughput when using this module in BTclassic and 1M baudrate? Would that be the same as HCI mode?
It would be helpful if you could share any data related to throughput testing in using Ez serial.
Thanks,
Se
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Per our internal test, the speed is 65 KBps from module to laptop and 35 KBps from laptop to module with flow control enable and no data loss.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Per our internal test, the speed is 65 KBps from module to laptop and 35 KBps from laptop to module with flow control enable and no data loss.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks XinghaoZ_26
Was it achieved with the hardware flow control or the software one?
Also, if I increase the baud rate, is that possible to achieve a throughput close to 100KBps from the module to laptop in Ezserial mode?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It is achieved with the hardware flow control by enable the flow control of PUART in the EZ-Serial FW.
The speed is limited by the data process and SPP transmission. Increase the UART baudrate will not help.