Creator 4.3 Can't Open CMSIS-DAP port

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
StNu_1610991
Level 4
Level 4
First comment on KBA 50 sign-ins 25 replies posted

Working with Creator 4.3 has been going well until Windows 10 was upgraded over-night.  Now the message "Can't Open CMSIS-DAP port" comes up whenever trying to compile.  I've run the PSoC 4.3 repair  and also the PSoC Programmer repair.  But, no luck so far.

Any ideas as to how to get over this?

0 Likes
1 Solution
StNu_1610991
Level 4
Level 4
First comment on KBA 50 sign-ins 25 replies posted

Problem solved.  By restarting windows a number of times and power cycling the PSoC 6 based unit, it eventually connected again.

In one windows setting screen it said that a COM port was not finished upgrading.  Likely that was the problem.

View solution in original post

0 Likes
1 Reply
StNu_1610991
Level 4
Level 4
First comment on KBA 50 sign-ins 25 replies posted

Problem solved.  By restarting windows a number of times and power cycling the PSoC 6 based unit, it eventually connected again.

In one windows setting screen it said that a COM port was not finished upgrading.  Likely that was the problem.

0 Likes