According to the CY8CKIT-044 demo kit schematic,
P1 and P1 are connected to PWM Temp Sensor.
Circuit diagram shown at the above URL Page 5 D2 area.
It is number '19' shown by the yellow circle in the board image above.
Thank you for your response.
So, Can I use this pins to connect an external resistors (for example) in the inputs of my opamp?
I think that it can be used by soldering the wire or external resistor.
TMP05 doesn't seem to shut-down in hardware.
Since the OUT pin of TMP05(U1) outputs PWM according to the temperature by CONV/IN pin,
So, I think this device needs to be removed.