- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Team,
I am using CY8CKIT-050 PSOC 5LP development kit. I am not able to see any COM port in my device manager.
I wanted to do a du[plex mode of communication between develpment Kit and PC using UCRT.
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to my response at the discussion below.
Re: Not able to see serial port enabled in teraterm for (CY8CKIT-050)PSOC 5LP
moto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi abho_4730071,
The CY8CKIT-050 PSoC 5LP Kit does not have an onboard USB-UART bridge (similar to KitProg) and that is why you are unable to find the COM port. Please refer to this thread and let me know if it helps - COM port on PSoC dev kit CY8CKIT-050 (USB-UART )
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Please refer to my response at the discussion below.
Re: Not able to see serial port enabled in teraterm for (CY8CKIT-050)PSOC 5LP
moto