0 Replies Latest reply on Oct 14, 2015 1:00 PM by bshaya

    Debugging address + size wrapped

    bshaya

      I am attempting to use my Olimex ARM-USB-TINY-H to debug my application on an ISM43362, but when I run debug, the code runs until an assert_param call in TIM_CtrlPWMOutputs in stm32f2xx_tim.c and then halts. Pressing resume doesn't seem to move forward. I set up my debug configuration based on this guide. My openocd_log is below. Every time I hit continue I get another copy of the last 5 lines. Any idea what I'm doing wrong?

       

      Info : only one transport option; autoselect 'jtag'

      trst_and_srst separate srst_gates_jtag trst_push_pull srst_open_drain connect_deassert_srst

      adapter speed: 1000 kHz

      adapter_nsrst_delay: 100

      jtag_ntrst_delay: 100

      Warn : target name is deprecated use: 'cortex_m'

      jtag_init

      Info : max TCK change to: 30000 kHz

      Info : clock speed 1000 kHz

      Polling target stm32f2xxx.cpu failed, GDB will be halted. Polling again in 100ms

      Info : JTAG tap: stm32f2xxx.cpu tap/device found: 0x4ba00477 (mfg: 0x23b, part: 0xba00, ver: 0x4)

      Info : JTAG tap: stm32f2xxx.bs tap/device found: 0x06411041 (mfg: 0x020, part: 0x6411, ver: 0x0)

      Info : Selecting JTAG transport command set.

      Info : AP INIT COMPLETE

      Info : stm32f2xxx.cpu: hardware has 6 breakpoints, 4 watchpoints

      Info : JTAG tap: stm32f2xxx.cpu tap/device found: 0x4ba00477 (mfg: 0x23b, part: 0xba00, ver: 0x4)

      Info : JTAG tap: stm32f2xxx.bs tap/device found: 0x06411041 (mfg: 0x020, part: 0x6411, ver: 0x0)

      Info : Selecting JTAG transport command set.

      Info : AP INIT COMPLETE

      Polling target stm32f2xxx.cpu succeeded again

      Info : Selecting JTAG transport command set.

      Info : AP INIT COMPLETE

      Info : accepting 'gdb' connection from 3333

      Info : device id = 0x20036411

      Info : flash size = 1024kbytes

      Warn : acknowledgment received, but no packet pending

      Info : Auto-detected RTOS: ThreadX

      Info : Padding image section 0 with 12 bytes

      Error: Not implemented: target_get_gdb_fileio_info_default

      Error: address + size wrapped(0xfffffffe, 0x00000004)

      Error: address + size wrapped(0xfffffffe, 0x00000004)

      Error: Not implemented: target_get_gdb_fileio_info_default

      Error: address + size wrapped(0xfffffffe, 0x00000004)

      Error: address + size wrapped(0xfffffffe, 0x00000004)

      Error: address + size wrapped(0xfffffffe, 0x00000004)

      Error: address + size wrapped(0xfffffffe, 0x00000004)