4 Replies Latest reply on Jul 8, 2020 1:36 AM by AkJa_4647796

    GPIO output issue.

    AkJa_4647796

      Hello,  AnjanaM_61

       

      I am using Hello sensor code. I am using an inextra output pin to drive an led(active low).  In hello_sensor_application_init() funct. After platform led() I have written.

      Wiced_hal_gpio_configure_pin(wiced_p26, GPIO_OUTPUT_ENABLE | GPIO_PULL_UP, GPIO_PIN_OUTPUT_HIGH);

      Wiced_hal_gpii_set_pin_output(wiced_P26,1);

       

      The problem is on power up. The Led turn on for few milliseconds and then turn off?  (After I reached to the initialisation). But I don't want the Led to be Turn On on power up?

      Thank you.