3 Replies Latest reply on Jul 2, 2020 7:05 PM by TakashiM_61

    Unable to connect ECU with WinIdea debugger


      Hi Team,


      Presently I have software stack which will be updated by another software stack (called as Updater stack).

      Both are differentiated and accessed with linker regions.


      This updater shall erase and copy the new stack and resets.


      Issue is after reset, the new stack copied should start because the startup code is available.

      But the microcontroller is going to idle state.


      Also unable to connect debugger after this copy.

      In WinIdea, during connection showing as finished but actually not connected. Because of this unable to update actual code.


      We have cross-checked the copy region and there is no access of wrong memory location/corruption.



      Sai Kumar Ponneri