EZ-Click, how to connect

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
DuSt_4713121
Level 1
Level 1

The user manual does not have any info on how to connect  the device; what do I need to connect the I2C lines to the computer that EZ-Click will recognize?

Dusan

0 Likes
1 Solution
Hari
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hi DuSt_4713121

MiniProg4 does not recognize the Ez-Click software. You can use the MiniProg3 for configuration.

EZclick support with Miniprog4

Thanks,
Hari

View solution in original post

0 Likes
3 Replies
Hari
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hi dust_4713121

The MBR3 kits have an onboard kitprog that does the conversion from I2C to USB. In case you are using a custom board, you can use any I2C to USB converters or a Miniprog for connection.

There is an option to "Select Target Device" in EZ-Click. Make sure that the MBR device is connected to the computer and it will show up in the available ports as shown in the figure.

pastedImage_0.png

Do let us know if the connection is successful.

Thanks,
Hari

0 Likes

I was looking more on a hardware solution. I have a cy8cmbr3110 on a custom board and access to the I2C pins. Can I use an CY8CKIT-005 MiniProg4 to connect?

Dusan

0 Likes
Hari
Moderator
Moderator
Moderator
750 replies posted 500 replies posted 250 solutions authored

Hi DuSt_4713121

MiniProg4 does not recognize the Ez-Click software. You can use the MiniProg3 for configuration.

EZclick support with Miniprog4

Thanks,
Hari

0 Likes