- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
Could you please share the the eye pattern for 2 downstream ports of CY7C65634-48AXC?
Best Regards
Arai
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Arai-san,
Please find the eye diagram for a single downstream port below, we currently dont have eye diagram tests done when two devices are connected on the downstream ports.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sananya san
Thank you for sharing the eye diagram. The reason for requesting two downstream ports was to check if there was a difference in the eye diagram for each. However, is it ok to assume that the eye diagram will be the same of the port?
Best Regards
Arai
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Arai-san,
Yes, it should be same for all the ports. The results shown were for the port with the longest trace on the board but all four ports have passed the compliance tests.
Best Regards,
Sananya
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Sananya san
Thank you for your answer.
Best Regards
Arai