- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Cypress
WE have OTA power issue ( Conduct power =15dBm / TRP = 8dBm ), It need to fine turn the RF parameter , Can you tell us What is AP and AZ for CYW43455 NVRAM , Do you have Document for RF NVRAM for reference , Thank !!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cypress Wi-Fi Regulatory Manual: https://www.cypress.com/file/453451/download
OTP Programming and NVRAM Development in SDIO Mode: https://www.cypress.com/documentation/application-notes/an214808-otp-programming-and-nvram-developme...
Describes the method for creating an nvram.txt file, which is then used to test a new board design, optimize NVRAM values, and program the one-time programmable (OTP) nonvolatile memory in a device that uses a WLAN SDIO host interface.
Which partner module are you using?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello:
Did you test the conducted power in different position like chip out, antenna point ?
then to judge where caused the power loss .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cypress Wi-Fi Regulatory Manual: https://www.cypress.com/file/453451/download
OTP Programming and NVRAM Development in SDIO Mode: https://www.cypress.com/documentation/application-notes/an214808-otp-programming-and-nvram-developme...
Describes the method for creating an nvram.txt file, which is then used to test a new board design, optimize NVRAM values, and program the one-time programmable (OTP) nonvolatile memory in a device that uses a WLAN SDIO host interface.
Which partner module are you using?