3 Replies Latest reply on May 3, 2020 8:59 PM by RakshithM_16

    Cannot program with my PSoC 6 Pioneer

    StMa_3607891

      I cannot program the target with my PSoC 6 Pioneer board.

      Often the target is not recognised by the programmer and when it does it starts programming and fails half way.

      LEDs 2 & 4 very erratic.

      The KitProg 3 is always shown in Windows Device Manager.

      I followed a suggestion I saw online to uninstall the driver and then re-install but that did not help.

       

      I opened up PSoC programmer and noticed that the Voltage reading on the programmer tab was visibly flatulating all over the place.

      PSoC programmer once told me that I needed to upgrade which I did successfully, but the problem still existed.

       

      Any ideas anybody please?