I just downloaded you project and duplicated the project to "Remote_Sensor_200430A".
And it could be compiled without problem.
Would you try "Clean and Build" your project?
And in case, you still have the problem please double check if the attached project was the same one.
P.S. Attached is the project I duplicated and compiled. (now cleaned and archived)
Sorry, I should have posted interim result.
I changed timer from 32bit to 8 bit and it compiled
However, when I run the code I do not get any timer interrupts occurring.
I enabled global interrupts before calling the Timer init routine in timer.c
I then start the timer component and hook up the isr to msTICK_INT, but this interrupt never gets called.
> Sorry, I should have posted interim result.
That's OK, I do similar things all the time.
I saw your schematic and made a couple of modifications
(1) Reconnect ISR to interrupt pin
(2) Enabled the TC interrupt
I hope with this the interrupt will be called.
BTW, if all you needed was a 1 ms periodical interrupt timer,
you could have used "SysTick." And using it will not consume UDB resource.
Following URL is my sample using SysTick.
I'll take a look at systick, That is all I need, a 1ms periodic interrupt.