2 Replies Latest reply on Apr 28, 2020 4:24 AM by gahe_4691766

    CYW20734 Help:How to get into DUT mode?

    gahe_4691766

      Start the BlueTool(ver0.1.55.1) application,save the UART option,then set the following options:

      a、Select7.3:Host Controller & Baseband Commands  from the command list, then double-click the

      Reset command.After double-clicking the Reset command, the log window should indicate Success for the reset

      status.

      b、Select7.3:Host Controller & Baseband Commands  from the command list, then double-click the

      Write_Scan_Enable(Inquiry and Page Scan enabled) command,the log window should indicate Success.

      c、Select7.6:Testing Commands,then double-click the Enable_Device_Under_Test_Mode command,

      the log window should indicate Success.

       

      Try to connect 20734,the log window event = 0x04(Connection Request), Link_Type = 0x01("ACL connection") ,a few seconds later,the log window event = 0x03(Connection Complete),Status = 0x10(Connection Accept Timeout Exceeded)..

       

      What else step can I do to solve this problem?By the way,is there an instruction manual for testing CE?