1 Reply Latest reply on Mar 23, 2020 5:54 PM by cycy_1740621

    Why in Denebola Development kit, the CX3´s Vss pins are connected to GND by 0E resistor?

    ArSa_3842301

      Hello, I am reading the schematic board of Denebola kit, and I have a simple question. Why some of  cx3's VSS pins are connected to GND by 0E? I mean, if you put a resistor between GND and Vss pin, you will probably have more ground bounce because of the resistor's inductance. It is not better, to connect GND and Vss pin directly by wire, how does it happen with other Vss pins in the same schematic?.

       

      Thanks so much.