- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am working on a small CY8C4127FNI-BL483, BLE project and I would like to do some RF testing preparing for the FCC certification.
Our RF consultant asked to place the transmitter into a continuous high power unmodulated mode.
I looked in the HCI mode , I did not find anything related to this. Any recommendation? thanks in advance.
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the firmware attached in this KBA linkTest Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073. You can use the test firmware for all regulatory testing and Bluetooth qualification testing of PSoC4 / PRoC BLE devices and modules.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Please refer to the firmware attached in this KBA linkTest Firmware for PSoC®/PRoC™ BLE RF Certification – KBA220073. You can use the test firmware for all regulatory testing and Bluetooth qualification testing of PSoC4 / PRoC BLE devices and modules.
Thanks,
P Yugandhar.