1 Reply Latest reply on Mar 19, 2020 9:42 AM by HemanthR_06

    How to handle the uart debug message in FX3S RAID-ON-CHIP USB DONGLE?


      Dear Sir,


      I downloaded img file of AN89661 USB RAID 1 Disk Design Using EZ-USB FX3S.zip in FX3S RAID-ON-CHIP USB DONGLE.

      USB DONGLE is working, but I can't see uart debug message.

      Can I see a uart debug message without H/W, S/W modification?(connector J1 - Pin8(UART_TX), Pin10(UART_RX))

      I think AppDebugPrint is printf fuction, is this right?

      I appreciate it if you know this question.

      Thank you.