5 Replies Latest reply on Mar 23, 2020 10:14 AM by RakshithM_16

    FAILED! Cannot enter Test Mode of PSoC6 device: CPU stopped at wrong address

    UrPl_1236626

      Hi,

       

      on one board with the CY8C6247BZI-D34 we face a strange error report from MiniProg3:

       

      | FAILED! Cannot enter Test Mode of PSoC6 device: CPU stopped at wrong address (0x100001AA).

                                                                         | Please, check the following items:

                                                                         |  - the connection between the programmer and the PSoC;

                                                                         |  - the correct programming protocol is selected;

                                                                         |  - the correct connector option is selected.

       

      The only thing it happened meanwhile is that USB - UART was connected to the same pins, if that possibly damaged the device; but if there is no connection to the device then the error is typically different to the one above.

       

      BR Uros