1 of 1 people found this helpful
Please let me know the firmware your are running on the FX3 device. If you are using the Superspeed Explorer Kit, make it enumerate as a bootloader device by populating PMODE jumper J4 and reset the FX3 device, check if it detected in the C++ bulkloop application.
Refer to the snippet below in which I have used the C++ bulkloop application and the FX3 device is detected.
thanks for your quick Reply.
Unfortunately I do not know which firmware is on the FX3, since it is installed on a preconfigured ONSemi Demo 3 Board. I do not have access to the source files.
For the bulkloop application it is the same issue: the C# version works, but the C++ version does not.
The following screenshot ist from the C# version:
I think I know what the problem is; unfortunately I can not test it until thursday.
I installed the driver that came with the Demo 3 board, which is using another GUID.
The C# version of the code uses 'USBDeviceList' which does not require a GUID.
The C++ version uses 'CCyUSBDevice' which requires a GUID (and uses the standard GUID if none is provieded).
I now replaced 'CYUSBDRV_GUID' with the GUID provided in my 'cyusb3.inf' file as described in the API documentation.
Hope it works now!
I will test as soon as possible and give feedback.
Your understanding is correct.
For the C++ application to detect the device the GUID used in the application for the CCyUSBDevice Class and the GUID of the driver (in the .inf file) to which the device is bound to should be the same.
I tested today with the correct GUID and it worked!
Thanks for your Support!