2 of 2 people found this helpful
Sounds like to you may need to perform a "Recover" process to get out. What are you working on?
Im using cp2102 module to connect with cybt-343151-02(hci uart) and trying the steps given in cyw 920706 wcdeval kit guide.
Is the module attached onto a motherboard of which you carry out the programming? Does it have provision for "Recovery" programming? If yes, then the follow the steps in the wcdeval kit guide. This process will get you into HCI mode, ready to re-program again.
If not, you may want to take a step back before you do those programming again. "Recovery" programming is necessary in modules because it allows you to re-program if something goes wrong during the process. Otherwise without this feature, the module is considered spent as one cannot recover it.
1 of 1 people found this helpful
Can you try to do the below?
1) short and hold pad 9 to ground
2) do a power reset
3) release the ground on pad 9
4) try to do a re-programming