I want to config ov5640 sensor to transmit raw8 format date in mipi mode. And ov5640 connect to a cx3 mipi port.I want to set the sensor configuration to be the same as the CX3 mipi controller configuration. I have the following problems:
1. For example, I set CSI Clock to 400MHz in CX3 mipi controller configuration project, how should I set this clock to ov5640 sensor?
2. If I change H-Blanking and V-Blanking (example:H-Blanking = 100 and V-Blanking = 200) in CX3 mipi controller configuration project, how should I set these value to ov5640 sensor?
I didn't find any registers for the above two questions in ov5640 datesheet, Whitch register should I config?Thank you!
Please contact OmniVision to understand which registers are to be configured for changing the CSI Clock, H blanking and V blanking of OV5640 sensor.