- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hey,
I have a board that has SCL connections to pins 49 and 60 and SDA connections to pins 53 and 61. I am trying to connect all 4 of these pins to the same I2C Master block. Is this possible? If so How do I do it?
I tried the design in the image, but that complains that the lines are driven more than once
Thanks
Amilcar
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Assuming that you are using LOGO for monitoring (output),
I could generate application with following schematic.
Note: The triangle is "Digital > Logic > Bufoe" and LOGO pins are "Bidirectional, Strong Drive"
Note2: I have not tested if it works or not.
moto
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Assuming that you are using LOGO for monitoring (output),
I could generate application with following schematic.
Note: The triangle is "Digital > Logic > Bufoe" and LOGO pins are "Bidirectional, Strong Drive"
Note2: I have not tested if it works or not.
moto