- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello sir .i am using the psoc 6 BLE pioneer kit CY8CCKI-062-BLE.i am doing the simply glow the LED but LED is not glow.i write this code also correct and no error.
please tell me what happen.
regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Open the PSoC Creator IDE, then open the PSoC 63 code example like the below figure:
The code example explains how to control the GPIO.
As you said, your code is right, one more question, do you use the Oscilloscope to test the actual voltage state of the pin you control?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Open the PSoC Creator IDE, then open the PSoC 63 code example like the below figure:
The code example explains how to control the GPIO.
As you said, your code is right, one more question, do you use the Oscilloscope to test the actual voltage state of the pin you control?