5 Replies Latest reply on Aug 18, 2015 12:00 AM by fishc_1849816 Branched from an earlier discussion.

    Questions about the design of the proposed BRCM J-Link Cable

      Have you guys made a J-Link cable yet?


      As far as custom cable, please clarify if my understanding is correct:

        - The cable doesn't need power, resistors or capacitors - we need to connect 5 wires from the J-Link connector to the board (PWR_VIO, SWDIO, SWDCLK, GND, RESET) and that's it

        - PWR_VIO and GND of the board can be connected to J-Link's pins 1 and 20, respectively