As you know, CCG3PA supports 100W(20V/5A). Also, CY4532 can support up to 24V/5A supply. The design can withstand up to 24V/5A supply. (This kind of description can be seen in the schematic)
100W supply system can achieve supplying power to DC TERMINAL (J2) instead of DC Jack (J3).
Regarding the modification instruction for both hardware and firmware is as follows.
For the usage of CY4532, kindly go through CY4532 Kit Guide. For detail, please go through the schematic.
They are considering using CY4532 as a PowerSource with PA 100W (20V/5A).I am understanding that various jumper settings, FW programming, etc., and plan to connect to the J2 terminal using a stabilized power supply from outside.
However, when looking at the schematic of CY4532, there are comments of LOAD ONLY FOR 24V OPERATION and NO LOAD FOR 24V OPERATION,
When operating the CY4532 at 20V / 5A (Power-Source), do I need to modify some of the resistance values on the board?If yes, would you please give me details on how to modify?
Why you do not read KBA?
I am misunderstanding the meaning of the following KBA question.
"Question: How do I add VCONN support to the EVK?"
I'm sorry.I follow the answer above.