- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I created project with PSoC Creator - FindMe example. Build passed ok , but then I failed to program the prototyping board. It asks me to upgrade the firmware with the PSoC Programmer. I go to the programmer --> Utilities, but the Upgrade firmware button is inactive.
What did I do wrong?
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ElLi_4422766,
Can you please try the resolution mentioned in this thread and see if that helps?
CY8CPROTO-063-BLE "Device was recognized but PSoC creator does not support using it this time."
Thanks and Regards,
Rakshith M B
Rakshith M B
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ElLi_4422766,
Can you please try the resolution mentioned in this thread and see if that helps?
CY8CPROTO-063-BLE "Device was recognized but PSoC creator does not support using it this time."
Thanks and Regards,
Rakshith M B
Rakshith M B