The memory requirements are based on the features used in the emWin library. Please find the approximate memory usage of each of the features here: https://www.segger.com/products/user-interface/emwin/technology/emwin-resource-usage/
The component specific resource usage can be found in the component datasheet. For example, the memory usage when using the GraphicsLCDCtrl component is as mentioned below:
In order for me to use serial flash, will I be needing Bootloader?
No, its not required.
Thank you for your response.
So correct me if I am wrong, if I was to use serial flash and use quad SPI to interface serial flash memory chip to PSoC 5 LP, when I build and program the chip it would automatically run the program from this newly interfaced serial flash memory?
Thanks and regards,