1 of 1 people found this helpful
For the purpose of demo, I connect a cyw920706wcdeval board to my PC and download the below app onto it.
In my device hardware manager, com5 is hci port and com6 is puart.
I use tera term to connect to com6 and do a reset of the eval board. Now follow the on-screen instruction and whatever
you type on the keyboard will be reflected on it. This app will give you an idea on how to use the puart driver interface to
send and receive.
I think this path is use for windows host
is any sample or sop to connect with a linux base host?
The reset process is carried out physically by pressing the "reset" button on my EVK, not via issuing a command.
thus question is for, may I use this J18 uart to sent hci reset command to check connection?
Pin 5 to 8 of J18 are dedicated pins of the HCI UART for 20706. You may issue HCI commands via here when the IC is rebooted in HCI mode. Do also ensure that all the pins of J26 are all closed on the eval board.
I assumed that you are using the cyw920706wcdeval board, then you may refer to the kit guide within the Doc folder of the SDK on how to recover this board. This will force the chip to reboot in HCI mode.
BoonT_56 , thank you and yes I am using cyw920706wcdeval
after reset using method in section Appendix D, I think this would be in HCI mode,
thus, I through J18 uart tx/rx to set try reset command through ubuntu like
"echo -e -n \\x01\\x03\\x0C\\x00 > /dev/ttySX" but not worked, could you comment on how to set "HCI reset" by through this , thank you
Can you create a new case for this query? Thanks.