1 Reply Latest reply on Dec 29, 2019 4:33 PM by RodolfoG_11

    UART: changing configuration on the fly

    AlBo_1871926

      Hello,

       

      For PSoC5LP it was impossible to change UART configuration on the fly (e.g. change datawidth, also parity, stopbits,). However it seems that in PSoC6 Cy_SCB_UART_Init() accepts cy_stc_scb_uart_config_t structure, where you could set all these parameters during init phase. Does it mean that now it is possible to change them at a runtime by calling DeInit()/Init() with new params?

       

      Thanks in advance.