- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi. cypress
In the SDK 3.4.0 CYPD3175-24LQXQ_Pa_direct_fb project, there is cable_comp.h, but it can't active as pic. I check the #define CCG_CABLE_COMP_ENABLE (1u) in config.h. All of information is gray, would you tell me how can I active it.I need add cable compensation in empty and full load.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
May I know why you open the cable_comp.h file in the project? This file is hide of firmware project by default. As you my know, the cable compensation is pre-build and link with lib. Refer below:
Best Regards,
Lisa
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi ,
May I know why you open the cable_comp.h file in the project? This file is hide of firmware project by default. As you my know, the cable compensation is pre-build and link with lib. Refer below:
Best Regards,
Lisa