Can you please let us know which CX3 Eval board are you using?
Does it matters?the cx3 exoposes the jtag I/f straight to the connector. It
is aciustom board btw
Il gio 12 dic 2019, 14:28 HemanthR_06 <firstname.lastname@example.org> ha
Cypress Developer Community
CX3 jtag debug
reply from HemanthR_06
in USB Superspeed Peripherals - View the full discussion
The reason for asking about the RDK is that, if you had Denebola RDK, then J-link Segger is the apt one since it has a connector for the same.
Since it is a custom board, you can go for
i) CY7C65215 (link for the kit is https://www.cypress.com/documentation/development-kitsboards/cyusbs236-usb-serial-dual-channel-development-kit)
Note that for JTAG to work on CY7C65215, UART and JTAG interfaces be simultaneously enabled.
ii) J-Link Segger can also be used.