Nov 25, 2019
12:34 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2019
12:34 PM
Hi,
is it possible to make a parallel to serial conversion?
I need to send a 32-bit data from USB and serialize it and send it to one pin of GPIF II and also add two other bits as frame sync and clock.(actually using 3-bit of GPIF).
I look at examples for modifying data before sending to consumer, but I have difficulties in bitwise modification in GPIF II.
Is there a more straightforward example or hints for me to follow?
Thanks
Solved! Go to Solution.
1 Solution
Nov 25, 2019
08:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2019
08:26 PM
Hi,
Can you please check the below article:
Configuring Serial OUT Interface in GPIF of FX3 – KBA228346
Regards,
Hemanth
Hemanth
1 Reply
Nov 25, 2019
08:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 25, 2019
08:26 PM
Hi,
Can you please check the below article:
Configuring Serial OUT Interface in GPIF of FX3 – KBA228346
Regards,
Hemanth
Hemanth