- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What is the representation of the components printed on the ground plane (see picture attached) ? I just want to confirm this is not decoupling capacitors required by the BCM20737S
Thanks!
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello 79 rpm,
From the post below, these are not simply decoupling caps.
Please look at the schematic here: iBeacon BCM20737S Reference Design PDF Schematic (Module)
Both R15 and R16 are needed on the SDA and SCL lines while R13 is used for UP_RX line.
Hope this helps.
Thanks
JT
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello 79 rpm,
From the post below, these are not simply decoupling caps.
Please look at the schematic here: iBeacon BCM20737S Reference Design PDF Schematic (Module)
Both R15 and R16 are needed on the SDA and SCL lines while R13 is used for UP_RX line.
Hope this helps.
Thanks
JT