Anonymous
Not applicable
Jun 30, 2015
01:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jun 30, 2015
01:53 AM
Hi,
I made Eagle part for BCM20737S and put it on GitHub.
aerialist/Eagle_BCM20737S · GitHub
It was actually my first time to make a part library thus I'm sure there are mistakes...
I tried to follow this excellent tutorial on Adafruit.
Introduction | KTOWN's Ultimate Creating Parts in Eagle Tutorial | Adafruit Learning System
As written in the readme, I followed the dimension of iBeacon reference design rather than that of the data sheet because data sheet doesn't seem to be accurate (too bad!).
I'd appreciate any improvement ideas, corrections and comments.
Best regards,
aerialist
Labels
- Labels:
-
PCBLayout
-
WICED Sense
0 Replies