2 Replies Latest reply on Sep 20, 2019 8:43 AM by BradyG_56

    Trackpad Prototype Development - How is this Handled?

    JoJo_4453281

      I am new to electrical engineering and the PSoC world, but I have spent the past few weeks learning a lot. I've read: "Getting Started with CapSense" as well as taken a close look at the PSoC 4 & 6 family of MCUs that work with Capsense and BLE.

       

      The next phase of development is building a prototype of some sort. I have the exact dimensions of the touchpad I need, but where to proceed from here is the big question. I can see that PSoC creator does basically all the work of connecting the MCU's Tx and Rx ports to all of the sensor electrodes and uses the sensor data to calculate finger position, but how to actually build a prototype to test out?