- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
can someone help in implementing a signal generator waveforms like sine , square, triangular , sawtooth using VDAC and UART in psoc 5lp . seti am struck at setting the frequency of waveform and how to vary fine and coarse frequency so that whatever the frequency entered through UART is generated and displayed on the Oscilloscope?
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello hare_4406026
You can use the waveform DAC component to generate the required waveforms. Please refer to this thread.
You can also refer to this appnote for more details. https://www.cypress.com/documentation/application-notes/an69133-psoc-3-psoc-5lp-easy-waveform-genera...
Thanks and regards
Hari
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello hare_4406026
You can use the waveform DAC component to generate the required waveforms. Please refer to this thread.
You can also refer to this appnote for more details. https://www.cypress.com/documentation/application-notes/an69133-psoc-3-psoc-5lp-easy-waveform-genera...
Thanks and regards
Hari