6 Replies Latest reply on Sep 15, 2019 9:38 PM by JuDa_1051176

    How to Debug the CYBLE-416045-02 using the SEGGER J-Link?

    JuDa_1051176

      I'm using the CY8CPROTO-063-BLE dev board and want to use the SEGGER J-Link to debug via SWD.

       

      The device is not in the J-Link Cypress list of supported devices. My question is, how can I configure the j-link to be able to debug on this dev board?

       

      Note: I removed the KitProg section of the pcb. I also provide power to the board via an external 3.3V source.

      I connected the J-Link and can see the Vtarg 3.3V.

       

      Any insight would be appreciated.