9 Replies Latest reply on Sep 5, 2019 7:02 AM by DheerajK_81

    PSOC4 4200 Programming Header Schematic

    joli_601446

      Hello, I'm using the PSOC4 4200 microcontroller to do the power up sequence for an FPGA board. I've chosen the PSOC4 because I can get a really low pin count device. I have a question about the RESET line from the Programming Header. I've decided to use a 10 pin header (2x5) to interface with the PSOC.

       

      PSOC4_4200_PROG_HEADER.jpg

      Is the RESET from the header the same RESET from my push button reset?

       

      PSOC4.jpg

      In the graphic above this is how I think it should be wired up. The board reset line is connected to the PSOC and connected to pin 10 on the header.

       

      Is this correct?

       

      Thanks,

      Joe