1 Reply Latest reply on Aug 19, 2019 1:37 AM by GauravS_31

    how to debug exception condition

    BaGo_4138971

      Hi All,

       

      I trying to send some data over UART but wiced send generating exception condition.

       

      How to check and debug exception .

       

      Thanks,

      Basavanagouda.

        • 1. Re: how to debug exception condition
          GauravS_31

          If we understood correctly, your WICED device UART is sending data bytes. The IFSR is set when there is a debug exception generated due to breakpoint. The IFSR=2 indicates debug event fault. Do you observe this issue in debug or run mode? Can you disable flow control and reduce the number of bytes transmitted?

          1 of 1 people found this helpful