- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I created a new CX3 Project (called MyImageSensor) using the "CX3 Configuration Tool" utility. After setting up the Image Sensor Configuration and CX3 Receiver Configuration, I saved the resulting cx3config.cycx file. Then, I tried to build the project (release version), and I get two (2) errors, which are listed below:
cs-make: *** [MyImageSensor.elf] Error 1 MyImageSensor C/C++ Problem
undefined reference to `main' cyfx_gcc_startup.S /MyImageSensor line 39 C/C++ Problem
None of the files were modified by me; It looks like that the utility is creating a problem.
Can anyone help?
Thanks and regards,
Mo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I saved the files (by clikcing on the file icon and then selecting the exposrt to file ...). Is this the right way to save these file?
You need to save these files by clikcing the icon below.
Anyhow, after saving the files, I was able to build, and I get the same console output as you do. However, under the "Problems" tab, I see a few warning and info message which are shown in the attached picture. Are these normal?
These warnings could be ignored.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Please attach the project here for checking.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
Thank you for your follow-up email.
The zipped project is attached. Also, I am showing the output of Eclipse so that you can actually see what it does at my desk.
If you happen to know what is wrong, I would like to know what the corrective action is so that if this happens again, I can fix it myself.
Thanks again for your help,
Regards,
Mo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have test the project you attached in previous reply. It could be built and the imgage file could be generated normally.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The problem is that you haven't saved all the files in red box and then built the project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks.
I saved the files (by clikcing on the file icon and then selecting the exposrt to file ...). Is this the right way to save these file?
Anyhow, after saving the files, I was able to build, and I get the same console output as you do. However, under the "Problems" tab, I see a few warning and info message which are shown in the attached picture. Are these normal?
Thanks again,
Mo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I saved the files (by clikcing on the file icon and then selecting the exposrt to file ...). Is this the right way to save these file?
You need to save these files by clikcing the icon below.
Anyhow, after saving the files, I was able to build, and I get the same console output as you do. However, under the "Problems" tab, I see a few warning and info message which are shown in the attached picture. Are these normal?
These warnings could be ignored.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You have been very helpful. Thanks again.
Regards,
Mo